FlightOps software change log 1.0.0.6 7/4/2008 Added support for CAN bus to RDAC interface 1.0.0.5 11/9/2007 Improved SD card interface recovery from unusual SD card events such as unexpected loss of card communications. Changed Slave processor communications interface to operate entirely on interrupt and PDC to improve communications. Slave processor changed to double primary flight sensor measurements to 4 x second (up from 2 x second), increased rate of message processing from RDAC(s), increased data transfer rate from slave to main processor. 1.0.0.4 6/8/2007 Added support for long filenames using alternate method for internal files. External files on MSDOS file systems remain 8:3 support only due to Microsoft licensing issues. Changed RDAC data distribution on USB to allow for longer packet sizes. 1.0.0.0 19/4/2007 Official "out of beta release". No change to anything. 0.1.1.1 18/4/2007 Added USB Host driver (HCD level of USB specification 2.0 for OHCI). Added Enigma master driver for USB host. Added Enigma slave driver for USB device. 0.1.0.9, 0.1.1.0 19/3/2007 Added support for boot loader 1.0.0.3. New architecture supported: Intel 8 MByte Flash top and bottom boot versions. Internal Flash drive capacity increase from 3 to 6 MByte. Flash program area increased from 1 to 2 MByte. 0.1.0.8 7/3/2007 Added support for new large font (Arial 20, proportional) and new font style (Edged font). Added new color palette support to switch between palette used for raster maps and vector maps (elevation data used for topographical terrain background). 0.1.0.6 4/12/2006 Increased SD/MMC card data rate by 20%. 0.1.0.5 30/11/2006 Slight speed inprovements for various drawing functions by replacing multiply instructions with cascaded binary shifts in some cases. 0.1.0.4 25/10/2006 Added support for Intel C3 top boot flash for Flash disk 0.1.0.3 24/10/2006 Minor update. Prevent setting of backlight levels below minimum in case of incorrect setup data (this would result in a black screen) 0.1.0.2 28/9/2006 Minor update. Improved drawing speed for rectangles that do not have an outline in a different color. 0.1.0.1 20/9/2006 Added initialization of Port A10. This was left undriven which caused the display enable signal to float. In one case this caused the display to work intermittently. 0.1.0.0 18/9/2006 Initial limited release